Cabinets with analog hygrometer with temperature reading and auto thermostat humidity control.Setting by turning the knob clockwise pointing ABCDE representing different humidity level, usual default .Setting from factory is at point C.
When turning the knob towards any point A-E, the green LED will turn on meaning the activation of the dry unit is process, this process may take a few hours depending on different setting points usually 3-4 hours at point D, The process of evaporating and adsorbing moisture will start again and repeat.
press the up and down keys to modify the settings.
Press the up key shows the temperature,automatic recovery humidity display after 3 seconds.
Press the down key to display the constant humidity, automatically recovery humidity display after 3 seconds.
Microcomputer freezing dehumidification system.
It adopts the latest TE cooling water design. When the humidity in the cabinet (RH %) exceeds the setting value, the microcomputer will activate cooling water automatically and the moisture will be condensed and frosted immediately on a collection board. When the humidity in the cabinet becomes lower than the setting value, the cooling water will deactivated automatically .Then, the frost on the collecting board refreezes to water, which is absorbed and given off naturally when flowing through guide holes, thus achieving dehumidification effect.
Cooling dehumidification system:
It makes use of the cooling and thermal performance of semi-conductor waters for raising its heat-singing capability, It is characterized by energy saving, noiselessness and rapid dehumidification.